Seams on Chiffon
Chiffon is soft, fluid, and sheer, and it moves under the needle. Seams on chiffon need close pinning, a gentle feed, and an enclosed finish, because the fabric will slip and pucker if it is handled roughly.
What chiffon is like to sew
Chiffon is a lightweight, plain weave fabric with a slightly rough texture and a soft drape. It can be made from silk, polyester, or another fibre, and it is used for blouses, scarves, evening wear, and overlays. It is sheer, so every stitch and every raw edge shows through it, and it is slippery, so the layers slide against each other as they are sewn.
The slipperiness is the main difficulty. Two layers of chiffon will not stay aligned on their own. They shift under the presser foot, they creep as the seam is sewn, and the finished seam can end up uneven, with one layer longer than the other. The fabric also frays easily and puckers if the stitch length or tension is wrong.
Chiffon also stretches on the bias. A seam cut on the bias, or a curved seam that crosses the bias, can stretch out of shape while it is being sewn. That stretching shows as a wavy seam that will not press flat. Handling the fabric as little as possible, and supporting it while it is sewn, keeps the stretching under control.
Keeping the layers together
Pinning is the first defence against slippage. Pin the seam closely, with pins placed about a finger width apart, and use fine pins that will not leave large holes. Some makers use more pins on chiffon than on any other fabric, and that is not overdoing it: the pins are doing the work that the fabric will not do on its own.
Basting by hand is the second defence. A line of long hand stitches along the seam holds the layers together while the machine seam is sewn, and it can be removed afterwards. Basting takes time, but on a slippery fabric it is often faster than unpicking a seam that slipped. It is especially useful on a long seam or a curved seam, where the layers have the most chance to shift.
A walking foot is the third defence. It feeds the top layer of fabric at the same speed as the feed dogs feed the bottom layer, so the two layers move together instead of one creeping ahead of the other. A walking foot is not essential on chiffon, but it makes the sewing noticeably easier, and many makers consider it the single most useful tool for this fabric.
The best seam for chiffon
A French seam is the usual choice on chiffon. It encloses the raw edges, which solves the fraying problem, and it gives a narrow, clean finish that suits the lightness of the fabric. The seam is sewn twice: once with wrong sides together, then again with right sides together, enclosing the first stitching. On chiffon, the first pass should use a narrow allowance, and the trimming should be done carefully, since the fraying edge can unravel while it is being handled.
A mock French seam is a useful alternative on a curved seam. Chiffon curves can be hard to sew as a full French seam, since the fabric slips and the curve distorts. A mock French seam is sewn as a plain seam, trimmed, folded, and stitched, which is easier to control on a curve. The result is still enclosed and neat.
A rolled hem or a narrow bound edge is sometimes used on chiffon instead of a seam, particularly on a scarf or a sheer overlay where the edge is visible. A bound seam, where the raw edges are wrapped in bias binding, adds a little weight that can help a chiffon garment hang better. An overlocked edge is not a good choice: it shows through the fabric and the cut edge frays underneath it.
Sewing the seam
- Use a fine, sharp needle and a fine thread. Test the stitch length and tension on a scrap of the same chiffon.
- Pin the seam closely, or baste it by hand, so the slippery layers cannot shift.
- Fit a walking foot if one is available, and sew slowly, letting the feed dogs move the fabric without pulling from behind the needle.
- Sew the first pass of the French seam with wrong sides together, using a narrow allowance.
- Trim the allowance close to the stitching and press it lightly, supporting the fabric so it does not stretch.
- Fold the fabric right sides together, press the fold, and sew the second pass, enclosing the first stitching completely.
Pressing chiffon
Press chiffon with a low heat setting and a press cloth. Chiffon can scorch or shine if the iron is too hot, and synthetic chiffon can melt. Test the iron on a scrap first. Press with the tip of the iron, briefly, rather than holding the iron down on the fabric.
Support the fabric while pressing. Chiffon stretches when it is hot and unsupported, so the seam should be pressed on a flat surface with the fabric lying naturally, not hanging off the edge of the board. Let the seam cool before moving the fabric, since chiffon holds the shape it is pressed into while it is hot.
Press each stage of the seam as it is sewn. Pressing the first stitching flat before folding makes the second pass easier and the finished seam neater. The finished seam should look like a narrow, smooth line with no ripples and no shine.
Do not pull chiffon from behind the needle while sewing. Pulling stretches the bias and leaves a wavy seam that will not press flat, even after the seam is finished.
Fixing a puckered or wavy seam
A puckered seam on chiffon usually means the tension is too tight or the stitch length is too short. Loosen the tension slightly, lengthen the stitch a little, and test again on a scrap. A wavy seam usually means the fabric was pulled or stretched while it was sewn. The fix is to unpick the seam, repin or baste it, and resew it slowly without pulling.
If the seam puckers only in one place, the fabric may have bunched under the presser foot at that point. Unpick back past the pucker and resew that section with the layers held flat. If the whole seam puckers, the machine settings are the problem, not the handling, and they should be tested on a scrap before the garment is sewn again.
Chiffon is one of the hardest fabrics to sew well, and a neat seam on chiffon is a real achievement. Slow down, pin closely, and let the machine feed the fabric, and the seams will come out as clean as the fabric deserves.